BPYLR - R 34-0002 EP LASER TYPE TONER
- MSDS: BPYLR
- Manufacturer: WESTERN DUPLICATING SUPPLIES
- Product Name: R 34-0002 EP LASER TYPE TONER
- National Stock Number: 6850-01-216-6823
Product Identification
Product ID:R 34-0002 EP LASER TYPE TONER
MSDS Date:03/01/1989
FSC:6850
NIIN:01-216-6823
MSDS Number: BPYLR
Responsible Party
SEATTLE, WA 98108
US
Emergency Phone: 206-767-5323
Info Phone: 206-767-5323
Cage: 0JPG6
Contractor
Telephone: 206-767-5323
Cage: 0JPG6
Ingredients
CARBON BLACK
CAS: 1333-86-4
RTECS: FF5800000
Fraction By Weight: < 5%
OSHA PEL 3.5 MG/M3
ACGIH TLV: 3.5 MG/M3; 9293
NON HAZARDOUS INGREDIENTS
Fraction By Weight: > 95%
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE AND CHRONIC- EXCESSIVE
INHALATION OF DUST CAN CAUSE IRRITATION OF THE RESPIRATORY TRACT.
DUST MAY CAUSE EYE IRRITATION.
Effects of Overexposure:EXCESSIVE INHALATION OF DUST CAN CAUSE
IRRITATION OF THE RESPIRATORY TRACT. DUST MAY CAUSE EYE IRRITATION.
Medical Cond Aggravated by Exposure:PERSONS WITH PRE-EXISTING
RESPIRATORY DISEASES MAY BE MORE SUSCEPTIBLE TO THE EFFECTS OF THIS
PRODUCT.
First Aid
First Aid:GET MEDICAL CARE IF NEEDED. INHALATION: REMOVE TO FRESH AIR.
EYES: IMMEDIATELY FLUSH WITH WATER FOR 15 MINUTES HOLDING EYELIDS
OPEN. SKIN: WASH WITH SOAP & WATER. INGESTION: RINSE MOUTH WITH
WATER. CO NSULT PHYSICIAN FOR MEDICAL ADVICE.
Fire Fighting
Flash Point:NONE
Extinguishing Media:CO2, FOAM/DRY CHEMICAL. WATER SPRAY MAY BE USED TO
KEEP FIRE EXPOSED CONTAINERS COOL.
Fire Fighting Procedures:WEAR FULL PROTECTIVE CLOTHING AND
NIOSH-APPROVED SELF-CONTAINED BREATHING APPARATUS. AVOID INHALATION
OF SMOKE.
Unusual Fire/Explosion Hazard:DUST MAY BE EXPLOSIVE IF MIXED WITH AIR
IN CRITICAL PROPORTIONS & IN THE PRESENCE OF AN IGNITION SOURCE.
Accidental Release
Spill Release Procedures:SWEEP UP OR VACUUM SPILLED TONER AND CAREFULLY
TRANSFER INTO A SEALABLE WASTE CONTAINER. SWEEP SLOWLY OR USE
VACUUM EQUIPPED RATED THE MOTOR AS DUST TIGHT. AVOID DUST
INHALATION. WEAR DUST MASK IF NEC ESSARY.
Neutralizing Agent:NOT APPLICABLE.
Handling
Handling and Storage Precautions:STORAGE- KEEP CONTAINER CLOSED. STORE
IN A COOL, DRY AREA AWAY FROM STRONG OXIDIZING AGENTS.
Other Precautions:AVOID CONTACT WITH EYES AND SKIN. AVOID PROLONGED
INHALATION OF EXCESSIVE DUST. WASH THOROUGHLY AFTER HANDLING.
Exposure Controls
Respiratory Protection:NONE NORMALLY REQUIRED. IN BULK TONER PROCESSING
FACILITIES, WEAR A NIOSH-APPROVED DUST RESPIRATOR.
Ventilation:NORMAL OFFICE CONDITIONS
Protective Gloves:NONE NORMALLY REQUIRED.
Eye Protection:CHEMICAL GOGGLES IF USING BULK TONER
Other Protective Equipment:EYE WASH STATION.
Work Hygienic Practices:OBSERVE GOOD PERSONAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. WASH THOROUGHLY BEFORE EATING OR DRINKING.
Supplemental Safety and Health
Chemical Properties
HCC:N1
Spec Gravity:1.5 - 1.7
Solubility in Water:NEGLIGIBLE
Appearance and Odor:FINE BLACK POWDER, MILD ROSINOUS ODOR
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS
Stability Condition to Avoid:FIRE, EXCESSIVE HEAT
Hazardous Decomposition Products:MAY FORM CARBON MONOXIDE AND CARBON
DIOXIDE.
Disposal
Waste Disposal Methods:DISPOSAL SHOULD BE IN ACCORDANCE WITH ALL
APPLICABLE FEDERAL, STATE AND LOCAL LAWS AND REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.